Philips DVP3005 - DVD Setup Menu: Video Adjustments; Progressive Scan Functionality; Picture Colour and Brightness Adjustments

English
27
DVD Setup Menu Options
TIPS:
To return to the previous menu, press 1.
To remove the menu, press SYSTEM MENU.
Sharpness
You can personalize your picture colour
by adjusting sharpness.
1 In ‘VIDEO SETUP PAGE’, press 3 4 to
highlight {SHARPNESS}, then press 2.
HIGH
Choose high to make the picture’s edge
sharper.
MEDIUM
Choose medium to get a standard
picture.
LOW
Choose low to make the picture’s edge
softer.
2 Press 3 4 to select a setting, then press
OK to confirm your selection.
Brightness / Contrast
Increasing the value will brighten the
picture or vice versa. Choose zero (0) for
average setting.
1 In ‘VIDEO SETUP PAGE’, press 3 4 to
highlight {BRIGHTNESS} or
{CONTRAST}, then press 2.
➜ The menu appears.
Brightness 0
Contrast 0
2 Press 1 2 to adjust the setting that best
suit your personal preference.
3 Press OK to confirm.
Progressive - turning on/off
In the progressive scan mode, you can
enjoy the high quality picture with less
flickers. It only works when you have
connected the DVD player’s Y Pb Pr jacks
to your TV that supports the progressive
video input. Otherwise, the a distorted
picture will appear on the TV. For proper
progressive scan set up, see page 16.
1 In ‘VIDEO SETUP PAGE’, press 3 4 to
highlight {PROGRESSIVE}, then press 2.
ON
To enable Progressive Scan function.
OFF
To disable Progressive Scan function.
2 Press 3 4 to select a setting, then press
OK to confirm your selection.
➜ Follow the instructions shown on the
TV to confirm the selection (if any).
➜ If a distorted picture appears on the TV
screen, wait for 15 seconds for auto
recovery.
Switching the YUV/RGB
This setting allows you to toggle the
output of the video signal between RGB
(on scart) and Y Pb Pr (YUV).
1 In ‘VIDEO SETUP PAGE’, press 3 4 to
highlight {COMPONENT}, then press 2.
YUV
Select this for Y Pb Pr connection.
RGB
Select this for Scart connection.
2 Press 3 4 to select a setting, then press
OK to confirm your selection.
Warning:
– When the player is set to Y Pb Pr
(YUV), some TV may not properly
synchronise with player on the
SCART connector.
– When RGB is selected,
progressive scan output will be
deactivated.