7
Find the TV input channel
1 Press to turn on this product.
2 Turn on the TV and switch to the video input
channel (refer to the TV user manual on how
to select the A/V input channel).
Select menu display language
1 Press SETUP.
» [General Setup] menu is displayed.
2 Select [OSD Language], and then press .
3 Press to select a language, and then press
OK.
Turn on progressive scan
Note
To use the progressive scan feature, you must connect a •
progressive scan TV with the component video jacks (see
“Connect” > “Connect audio/video cables” > “Option 1:
Connect to the component video jacks” for details).
1 Turn on the TV to the video input channel for
this product.
2 Press SETUP.
3 Press to select [Video Setup].
Note
This product can only play/view MP3, WMA, DivX •
(Ultra) or JPEG files that are stored on a USB flash drive.
Press the
• button to access the content and play
the files.
Connect power
Caution
Risk of product damage! Ensure that the power supply •
voltage corresponds to the voltage printed on the back
of the product.
Before connecting the AC power cord, ensure you have
•
completed all other connections.
Note
The type plate is located on the back of the product. •
1 Connect the AC power cable to the wall
socket.
The product is ready to be set up for use. »
4 Get started
Prepare the remote control
1 Press and push to slide open the battery
compartment (see “1” in the illustration).
2 Insert two R03 or AAA batteries with correct
polarity (+/-) as indicated.
3 Push to slide back the battery compartment
(see “3” in the illustration).
Note
If you are not going to use the remote control for a long •
time, remove the batteries.
Do not use old and new or different types of batteries
•
in combination.
Batteries contain chemical substances, so they should be
•
disposed of properly.
EN
To Next Page
Loading...
