Philips DVP721VR/02 Quick Use Guide

1
Disconnect all equipment from the power outlets. Connect the equipment to the power outlets only after you
have finished hooking up everything. Never make or change connections with equipment connected to the power outlet.
2
Connect the EURO AV1 AUDIO/VIDEO on the rear panel of this DVD/VCR to the SCART input on the TV
using the SCART cable (supplied).
3
Connect your existing RF cable from the Antenna TV signal directly to the AERIAL jack on the rear of the
DVD/VCR.
If you have a Cable Box (or Satellite Receiver), connect the OUT jack of the Cable Box/Satellite Receiver to the AERIAL
jack on the DVD/VCR using an RF coaxial cable (not supplied).
4
Connect the supplied black RF coaxial cable to the DVD/VCR’s RF-OUT jack and to your TV’s ANTENNA IN
jack. The TV’s ANTENNA IN jack could be labelled 75-ohm, TV IN, or RF IN. Check your TV manual for details.
5
Connect the power cords of the DVD/VCR,TV, and Cable Box (if applicable) to a power outlet.
6
Turn on the TV power. Set the TV to a video channel. (See the accompanying DVD/VCR owner’s manual for
details.)
7
Press STANDBY-ON 2 on the DVD/VCR or its remote to turn on the DVD/VCR. The first time you turn
on the DVD/VCR, you should complete the VCR setup. See the other side of this Quick-Use Guide for details.
SCART IN
SCART IN
IN
OUT
RF
CABLE
CABLE
TV SIGNAL
Antenna
Cable box (optional)
3
4
5
2
12NC: 8239 300 33262
SgpSL/0434/02_2
DVP721VR/02

Philips DVP721VR/02 Specifications

Operating Environment

operating temperature	5˚C to 35˚C
operating humidity	5 % to 90 %

Power

power requirements	AC 220-230V, 50Hz
power consumption	19W

System Specifications

laser wavelength	650 nm
frequency response DVD (PCM 96 kHz)	8 Hz to 44 kHz
frequency response DVD (PCM 48 kHz)	8 Hz to 22 kHz
frequency response CD	8 Hz to 20 kHz
signal-to-noise ratio	More than 100dB
harmonic distortion	Less than 0.008%
dynamic range DVD	More than 100 dB
dynamic range CD	More than 95 dB

Inputs & Outputs

audio input (SCART)	-6.0dBm, more than 10 kohms
audio input (RCA)	-6.0dBm, more than 47 kohms
video input	1.0 Vp-p, 75 ohms
video output	1 Vp-p 75 ohms
s-video output (Y)	1 Vp-p 75 ohms
s-video output (C)	0.3 Vp-p 75 ohms
component video output (Y)	1 Vp-p 75 ohms
component video output (Pb/Pr)	0.7 Vp-p 75 ohms
rgb output	0.7 Vp-p 75 ohms
audio output (digital audio)	0.5 V (p-p), 75 ohms
audio output (optical audio)	3 V (p-p), 75 ohms
audio output (analog audio)	2.0 Vrms, 600 ohms

Weight and Dimensions

dimensions	430 X 78.5 X 265 mm
mass	4.06 kg