Philips DVT7000/00 - Device Settings and Customization; Record Settings: External Sound Source

47
Settings
Table of contents
9.1.13 Enable/disable the record indicator
This fuction allows you to switch o the status LED.
1
In stop mode (start-up screen), press MENU.
2
Press h / b to select the device settings menu Õ.
3
Press + / – to select the Record lamp function.
4
Press the record key, g, to confirm.
5
Press + / – to enable/disable the LED indicator.
6
Press the record key, g, to confirm.
7
Press the j key to exit the menu.
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.
9.1.14 Selecting an external sound source
If you connect an external microphone to the device, the recording
source will switch automatically and the device's microphone will be
turned o. When you connect a mono microphone or an amplified
recording source (e.g. a stereo system) to the microphone port
(DVT3000 – DVT7000), you should set the external source.
1
In stop mode (start-up screen), press MENU.
2
Press the h / b key to select the record settings menu Ó.
3
Press + / – to select the External input function.
4
Press the record key, g, to confirm.
5
Press + / – to connect an external mono or stereo microphone, or
an amplified recording source (
Line-in).
6
Press the record key, g, to confirm.
7
Press the j key to exit the menu.
X When you use
Line-in, the Ë icon will be displayed.
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.