-
The hook is not positioned correctly if it is still in bottommost position.
3 Slide the brew group back into the machine along the guiding rails on the
sides until it locks into position with a click.
Caution: Do not press the PUSH button.
4 Close the service door.
Lubrication
For optimal performance of the machine, you have to lubricate the brew
group. See table below for the lubrication frequency. For support videos visit
our website: www.philips.com/coffee-care.
Usage frequency Nr of beverages brewed daily Lubrication frequency
Low 1-5 Every 4 months
Normal 6-10 Every 2 months
Heavy >10 Every month
1 Switch off the appliance and unplug it.
2 Remove the brew group and rinse it under a lukewarm tap (see 'Cleaning
the brew group under the tap'). Then let it air-dry.
3 Apply a thin layer of grease around the shaft in the bottom of the brew
group.
4 Apply a thin layer of grease to the rails on both sides (see figure).
5 Reinsert the brew group (see 'Reinserting the brew group').
You can use the grease tube multiple times.
Cleaning the milk carafe
Carafe quick clean
After preparing a milk-based beverage, the carafe cleaning icon appears on
the display.
1 When the carafe cleaning icon appears on the display, press the OK
button if you want to perform a cleaning cycle. You have 30 seconds to
activate the quick clean procedure. Press the escape button if you do not
want to perform the quick clean procedure.
17
English
To Next Page
Loading...
