8
English
Using your Philips Sonicare toothbrush
Brushing instructions
1 Wet the bristles and apply a small amount of
toothpaste.
2 Place the toothbrush bristles against the teeth
at a slight angle (45 degrees), pressing rmly to
make the bristles reach the gumline or slightly
beneath the gumline.
Note: Keep the center of the brush in contact
with the teeth at all times.
3 Press the power on/o and mode button to
turn on the Philips Sonicare.
4 Gently keep the bristles placed on the teeth
and in the gumline. Brush your teeth with
small back and forth motion so the bristles
reach between the teeth. Continue this motion
throughout your brushing cycle.
Note: The bristles should slightly are. Do not
scrub.
5 To clean the inside surfaces of the front teeth,
tilt the brush handle semi-upright and make
several vertical overlapping brushing strokes on
each tooth.
Note: To make sure you brush evenly
throughout the mouth, divide your mouth into
4 sections using the Quadpacer feature (see
chapter ‘Features’).
4235_021_0677_1_Booklet_A6_v2.indd 8 18/11/15 10:48
To Next Page
Loading...
Need help?
General
