Philips FC6120 - Preparing for use; Charging

Before rst use
1
Pull the handle upwards until it is in upright position. (Fig. 2)
2 Charge the appliance for at least 16-18 hours before you use it for
the rst time (see chapter ‘Charging’).
Preparing for use
1
Connect the upper handle to the top part of the stick.
2 Connect the top part of the stick to the bottom part of the stick
(‘click’). (Fig. 3)
If you want a long stick to suit your height, connect the middle part of the
stick to the bottom and top part of the stick
3 Connect the stick to the lower handle of the sweeper base
(‘click’) (Fig. 4).
To remove the stick, press the button on the lower handle (1) and
pull the stick upwards (2). (Fig. 5)
Charging
Charge the appliance for 16-18 hours.
Only charge the appliance when the battery pack is low to avoid
overcharging.
When the appliance is fully charged, it has an operating time of 25
minutes on hard oors. On carpet, the operating time is shorter due to
higher friction.
1 Switch off the appliance before you charge it.
2 Place the stick in upright position (‘click’) (Fig. 6).
3 Insert the small plug into the socket on the sweeper base (Fig. 7).
4 Insert the adapter into a wall socket.
The charging light is on continuously during charging and after the
battery is fully charged. The charging light goes out when you
disconnect the appliance from the mains.
-
,
ENGLISH8