Philips FC6148 - Setup and Operation; Charger Installation Guide; Appliance Charging Procedure; Vacuum Cleaner Operating Instructions

Preparing for use
Installing the charger
1 Attachthechargertothewallasshowninthegure.(Fig.2)
If you attach the charger to the wall, the space between the screw holes
has to be 12cm.
2 Youcanalsoplacethechargeronahorizontalsurface(e.g.atable
ordesk)(Fig.3).
3 Windexcessmainscordaroundthereelinthebackofthecharger
andpassthecordthroughtheslot(Fig.4).
Charging the appliance
Charge the appliance for at least 16 hours before you use it for the rst
time.
Tip: If you are not going to use the appliance for a longer period of
time, remove the adapter from the wall socket to save energy.
1 Makesuretheapplianceisswitchedoff.
2 Puttheadapterinthewallsocket.
3 Placethevacuumcleaneronthecharger(Fig.5).
- Make sure you place the opening in the back of the vacuum cleaner
on the hook of the charger (Fig. 6).
, Thecharginglightashestoindicatethattheappliance
ischarging(Fig.7).
, Thecharginglightisoncontinuouslytoindicatethattheappliance
isfullycharged.
Using the appliance
1 Pushtheon/offslideforwardstoswitchontheappliance(Fig.8).
- If you want to use normal power, select speed 1.
- If you want to use high power, select speed 2.
2 Pushtheon/offslidebackwardstoswitchofftheappliance(Fig.9).
ENGLISH8