19
See the separate supplied instruction manual with your monitor.
Connect your computer
& Connect your camera or camcorder to the front input behind the
door at the front side of your receiver. Press the center of the
door to open.
é Connect the equipment to VIDEO IN 2 and AUDIO L 1 for
mono equipment.
“ For stereo equipment also connect AUDIO R 1.
S-VHS quality with an S-VHS, Hi-8 or Digital camcorder is
obtained by connecting the S-VHS cables with the S-VHS input 3
(instead of
VIDEO IN 2) and AUDIO inputs 1.
Camera & camcorder
S•VHS
VIDEO IN
AUDIO
L
R
1 2
3
& Insert the plug into the headphone socket L behind the door at
the front side of the receiver. Press the center of the door to
open.
é Press ¬ on the remote control to switch off the internal
loudspeakers of the TV.
The headphone impedance must be between 8 and 2000 Ohm.
The headphone socket has a 3.5 mm jack.
In the
SOUND menu select Headphone volume to adjust the
headphone volume.
Note:When a TV channel or external source is blocked via the Channel
Lock menu (see p. 12), also the headphone is muted.
When Dual Screen/PIP is activated (see p. 15):
- if the main screen displays a TV channel picture, you hear the sound
from the Dual Screen/PIP picture through your headphone.
Headphone
Devices connected to the rear or on the front side of the receiver box
& Press the v button to select AV1, AV2,AV3, AV4,AV5, FRONT,VGA or TV
channels according to where you connected your devices at the rear or on
the front side of your receiver.
é Press the cursor up/down.
“ Press OK.
Remark : most equipment (decoder, video recorder) carries out the switching itself.This is
however never the case with a computer connected to the VGA input.
If you want to change to TV channels?
Enter the channel number of the TV channel which you want to watch with the
digit buttons.
To select connected devices
B
v
Select
VCR DVD SAT AMP
OK
Ò
®
‡π
†
®
®
®
x
CBL
CC
l
l
v
To Next Page
Loading...
