Philips FW 80 - CD Program Management; Storing, Checking, and Erasing CD Programs

English
Programming
STORING A PROGRAM _
You can store up to 20 tracks of a CD in any required sequence
in a program. All play functions (play, shuffle and scan) will
then use this program. To create a program repeat the follow¬
ing two steps until the program is finished.
Select a desired track
• On your remote control, press NEXT or PREVIOUS until the
desired track appears on the display or select the track
directly by pressing the desired combination of numeric
keys.
• On your CD player, press or »\ 1 until the desired track
appears on the display.
Store the track
• Press PROG 12 to store the selected track.
If you pressed PROG in the stop mode, the display shows
SELECT TRACK.
The display shows the number of tracks and the playing time
of your program for 2 seconds.
The track number indicator (music calendar) shows which
numbers have been stored.
Notes:
- It is also possible to store the track currently playing in scan,
shuffle and normal play mode.
- The display will show the message FULL if you try to exceed
the maximum of 20 tracks.
- The display will show -: - (after pressing PROG 12) if the
inserted CD has more than 29 tracks, if you programmed a
tracknumber above 29, or if the total programmed time
exceeds 100 minutes.
- It is possible to compile a program when the CD TRAY 4 is
open. The display will show WRONG TRACK after the clos¬
ing of the CD TRAY 4, if you have stored a non existent
track. If the entire programme does not exist, the message
PROGRAM CANCELLED will be shown.
CHECKING THE PROGRAM _
It is possible to quickly check the contents of the program
using the REVIEW function.
• Press REVIEW 10 to display each track number for 2 sec¬
onds in the programmed sequence.
• Press REVIEW 10 again to interrupt the review function.
Notes:
- The display shows NO PROGRAM ACTIVE if no tracks have
been stored yet.
- If REVIEW 10 is pressed during programmed play, only the
current track and the tracks still to come will be displayed.
PLAYING THE PROGRAM _
• Press PLAY/PAUSE 16 or PLAY on the remote control. The
display shows PROGRAM PLAY.
Playback starts with the first programmed track.
Notes:
- All keys (except EDIT, PROG, CLEAR, TITLES and FTS) can
be used during programmed play.
- Searching for a particular passage is only possible within the
track being played.
ERASING A (TRACK FROM THE) PROGRAM _
It is possible to erase a selected track from the program or to
erase the whole program.
• To erase the whole program, press CLEAR 11 in the stop
mode or press OPEN/CLOSE 14 (OPEN/CL on the remote
control).
The message PROGRAM CANCELLED appears on the dis¬
play.
• To erase a selected track from the program, press REVIEW
10 in the stop mode and press CLEAR 11 as soon as the
track number you want to erase appears on the display.
Note:
- If CLEAR 11 is pressed and no program has been stored, the
display will show the message NO PROGRAM ACTIVE.
22