2-2
2-2
Service pos A
Service pos B
Note: After re-assembly, it is very important to ensure the
wires from the Tape mechanism are routed properly
to ensure that they do not touch/obstruct all moving
parts.
Dismantling of the Front Panel and Bottom Panel assembly
Figure 6
Figure 7
Figure 8
1) Remove 8 screws D mounting the Front board.
2) Remove 1 screw E supporting the bracket, Combi board
(pos 33) to the Panel front (pos 8).
3) Remove 1 screw F (see figure 5) mounting the Mains
transformer body to the Panel Bottom (pos 25).
Note: Care must be taken not to damage the board
because of the heavy Mains transformer.
4) The Front and Combi boards together with the Mains
transformer can now be remove.
5) Loosen 6 screws G and eject both cassette doors to
remove the Tape mechanism (pos 12).
Note: During re-assembly of the Tape mechanism
and Front board care must be taken to ensure
the wires are properly dressed and not touch-
ing any moving parts on the Tape mechanism.
To Next Page
Loading...
