23
English
Dubbing tapes
(from tape deck 2 to tape deck 1)
1 Load the prerecorded tape into tape deck 2 and a blank
tape into tape deck 1.
™ Make sure that both tapes have their full spool to the
left.
2 Press DUBBING to switch between normal and high
speed dubbing.
™ "NORMAL" (normal speed) or "FAST" (high speed)
will be displayed.
™ HSD flag appears on the display for high speed
dubbing.
3 Press PAUSE on tape deck 1.
4 Press RECORD on tape deck 1.
5 Press PLAY on tape deck 2.
™ Recording will start automatically.
™ The REC flag starts flashing.
6 Press STOP•OPEN on tape deck 1 and tape deck 2 to
stop dubbing.
Notes:
– At the end of side A, flip the tapes to side B and repeat
the procedure.
– Dubbing of tapes is only possible from tape deck 2 to
tape deck 1.
– To ensure good dubbing, use tapes of the same length.
– During high speed dubbing in Tape mode, the sound is
reduced to a low volume.
CD Synchro Start Recording
During CD synchro start recording,
• It is not advisable to fast forward/rewind your tape in
tape deck 2.
• It is not possible to listen to another source.
1 Load a blank tape into tape deck 1 and a disc into the
disc tray.
2 Press CD.
• You can program the tracks in the order you want them
to be recorded (see Programming Tracks). If not, the
tracks are recorded according to the selected disc.
3 Press RECORD on tape deck 1 to start recording.
4 Press STOP•OPEN on tape deck 1 to stop recording
and STOP•CLEAR Ç to stop CD playback.
Recording from other sources
(only on tape
deck 1)
1 Load a blank tape into tape deck 1.
2 Press CD, TUNER, TAPE or AUX.
• Start playback of the selected source.
3 Press RECORD on tape deck 1 to start recording.
™ The REC flag is flashing.
4 Press PAUSE to interrupt recording.
5 Press STOP•OPEN on tape deck 1 to stop recording.
Note:
– During recording, it is not possible to listen to another
sound source.
RECORDING
To Next Page
Loading...
