Philips FW890P - Bass Boost and Calibration

15
English
3139 116 18731
5 Press ENTER to confirm the store
location.
• Repeat 1 – 5 to adjust the other
personal settings.
Rotate the JOG to adjust the speed of
the effect after selecting SURF,
STROBE, PAN or HOLD.
SURF
This feature allows you to simulate the
sound effect like an ocean wave.
• Press SURF.
™ "SURF XX" will be displayed.
STROBE
This feature allows you to simulate a
stroboscopic sound effect.
• Press STROBE.
™ "STRB XX" will be displayed.
PAN
This feature allows you to simulate a
panoramic sound effect.
• Press PAN.
™ "PAN XX" will be displayed.
OPERATING THE SYSTEM
HOLD
This feature allows you to simulate the
sound effect like scratching a vinyl LP
record and is only applicable during CD
play mode.
• Press HOLD.
™ "HOLD XX" will be displayed.
Note:
–" XX " is the speed of the effect.
– All other sound effects will be switched
off when SURF, STROBE, PAN or HOLD
is selected.
DYNAMIC BASS BOOST (DBB)
There are three DBB settings to enhance
the bass response.
• Press DBB briefly to select a bass boost
level.
™ The respective DBB level is being
encircled and lit.
™ “BEAT, PUNCH or BLAST” will
be displayed.
To switch off DBB
• Press DBB briefly until “DBB OFF” is
displayed.
Note:
– Some CDs or tapes might be recorded in
high modulation. It may cause distortion
at high volume. If this occurs, switch off
DBB or reduce the volume.
Automatic DSC-DBB selection
The best DBB setting is generated
automatically for each DSC selection. You
can manually select the DBB setting that
best suits your listening environment.
MUTE (on remote control only)
This feature allows you to temporarily
switch off the sound without switching off
the system when you require a moment of
silence.
• Press MUTE on the remote control to
switch off the sound.
™ “MUTE” will be displayed.
• Press MUTE again on the remote
control or increase the VOLUME level
to switch on the sound.