Philips FWD17/21M - Page 2

Connect the speaker wires to the SPEAKERS terminals, right speaker to "R" and left speaker to "L", coloured
(marked) wire to "+" and black (unmarked) wire to "–". Fully insert the stripped portion of the speaker wire into
the terminal as shown.
For radio reception, connect the supplied MW loop antenna to the "AM aerial" terminal.
Use the composite video cable (yellow) to connect the system’s VIDEO OUT jack to the video input jack (or
labeled as A/V In, Video In, Composite or Baseband) on the TV set. (Option A)
Use the component video cables (red/blue/green) to connect the system’s Pr/Cr Pb/Cb Y jacks to the
corresponding Component video input jacks on the TV set. (Option B)
Connect the power cord of the DVD system to the AC power outlet.
1
2
3
4
Speaker
(Right)
Speaker
(Left)
FM antenna
1
4
3
2
1
AC power cord
MW loop
antenna
A
B
Tip
It is unnecessary to connect the FM pigtail antenna since it is fixed to the main unit.
Tip
– Set the VIDEO OUT (put) to ‘Cr Cb Y’ if you select Option B.
– See the User Manual for other TV connection options.
FWD17 QUG_Eng 2005.5.25, 2:38 PM2