3-1 3-1
DISMANTLING INSTRUCTIONS
Dismantling of the Cassette Cover
Dismantling the 3CDC Module
4) Remove the Cover Tray as shown in figure 4.
5) Loosen 4 screws A to remove the CDC Module (pos 1105)
as shown in figure 3.
Dismantling of the Cover Front Display and Cover Front Ornamental (pos 130)
Notes: There is nothing are sandwiched between the
Front Cabinet (pos 101) and Cover Front Display
(pos 129) but it has to be removed in order to
reach the catches for the Cover Front
Ornamental (pos 130) .
1) Loosen the 4 screws, slide Cover top (pos 255) towards
the rear and remove it upwards.
3) Push the gear slowly towards the front as shown in figure
3 until the CDC tray starts to move out of the Front Cabinet.
The CDC tray is now disengaged and can be pulled out
completely.
1) Remove the Volume knobs as stated in Dismantling the
Cover Front Display in Figure 5.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Pull out
Press and hold it
between the tape
deck and the
cassette door
A
A
Turn the gear towards
the front till the CDC
tray starts to open
To Next Page
Loading...
