Philips FWM154/12 - Get Started; Connect Speakers; Install Remote Control Batteries

11
Install remote control
batteries
Caution
Risk of explosion! Keep batteries away from heat, •
sunshine or  re. Never discard batteries in  re.
Risk of decreased battery life! Never mix different
•
brands or types of batteries.
Risk of product damage! When the remote control is
•
not used for long periods, remove the batteries.
1 Open the battery compartment.
2 Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
FM ANT
LOOP ANT
Speaker
(Right)
Speaker
(Left)
3
1
2
3 Get started
Caution
Use of controls or adjustments or performance •
of procedures other than herein may result in
hazardous radiation exposure or other unsafe
operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Connect speakers
Note
Ensure that the colors of the speaker wires and •
terminals are matched.
1 Hold down the socket  ap.
2 Insert the stripped part of the wire
completely.
Insert the right speaker wires to “ • R ”,
left speaker wires to “ L ”.
Insert the red wires to “ • + ”, black
wires to “ - ”.
3 Release the socket  ap.
abc
English
EN
):0B%RRNLQGE6HF):0B%RRNLQGE6HF 