20
English
Selecting a preset radio station
● In tuner mode, press – or + (or í/ë on the
remote control).
➜ The preset number, radio frequency, and
waveband are displayed.
Deleting a preset radio station
● Press and hold Ç until “PRESET DELETED” is
displayed.
➜ The current preset radio station will be
deleted.
➜ All other preset radio stations with higher
numbers are decreased by one.
RDS
RDS (Radio Data System) is a service that
allows FM stations to show additional
information. If you are receiving a RDS station,
RDS and the station name are displayed.
Scrolling through RDS information
● Tuned to a RDS radio station from FM band,
then press AUTO REPLAY•RDS repeatedly
to select the following information (if available):
– Station name
– Programme type (for example: News, Affairs,
Sport, etc.)
– Radio text messages
– Frequency
Setting the RDS clock
Some RDS radio station may be transmitting a
real clock time at an interval of every minute. It
is possible to set the clock by using a time signal
which is broadcast together with the RDS signal.
1 Tune to a RDS station from FM band (refer to
“Tuning to radio stations”).
2 Press and hold CLK/TIMER (or
CLOCK•TIMER on main unit) until “SELECT
CLOCK OR TIMER” is displayed.
3 Press ë/+ to change the display to “CLOCK”
and press CLK/TIMER (CLOCK•TIMER)
again to confirm.
4 Press AUTO REPLAY•RDS.
➜ “SEARCH RDS TIME” is displayed.
➜ When RDS time is read, the current time will
be stored.
➜ If the RDS station does not transmit RDS
time within 90 seconds, “NO RDS TIME” is
displayed.
Note:
– Some RDS radio stations may be transmitting a
real time clock at a minute interval. The accuracy
of the transmitted time depends on the
transmitting RDS radio station.
Tuner Operations
To Next Page
Loading...
