12
English
Step 5: Connecting the AC
power cord
“AUTO INSTALL - PRESS PLAY” may appear
on the display panel when the AC power cord is
plugged into the power outlet for the first time.
Press ÉÅ on the main unit to store all available
radio stations (page 3 – P3) or press Ç to exit
(refer to “Tuner Operations”).
Step 6: Connecting the Power
Booster
R
SPEAKERS 6Ω
+
–
–
+
BOOSTER IN
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
ON
POWER SWITCH
OFF
R
L
R
L
L
7
1
2
3
4
5
6
AC MAINS
VOLTAGE
SELECTOR
110V-
127V
220V-
240V
1 Connect the BOOSTER OUT (Right and
Left) terminals of the mini system to the power
booster amplifier BOOSTER IN (Right and
Left) terminals respectively.
2 Connect the speaker wires to the BOOSTER
SPEAKERS terminals, right speaker to "R" and left
speaker to "L", coloured (marked) wire to "+"
and black (unmarked) wire to "-".
3 Set the VOLTAGE SELECTOR to the local
power line voltage.
4 Plug in the AC mains to the wall socket.
5 Switch on the POWER SWITCH to activate
the power booster amplifier.
6 Press STANDBY ON button to switch the
system ON or to Standby mode.
7 Rotate the VOLUME control to adjust the
loudness of the power booster amplifier.
Connections
Step 7: Inserting batteries into
the remote control
1 Open the battery compartment cover.
2 Insert two batteries type R06 or AA, following
the indications (+-) inside the compartment.
3 Close the cover.
Using the remote control to operate the
system
1 Aim the remote control directly at the remote
sensor (iR) on the main unit.
2 Select the source you wish to control by
pressing one of the source select keys on the
remote control (for example CD, TUNER).
3 Then select the desired function (for example
ÉÅ,
í,
ë).
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
To Next Page
Loading...
