Philips FWM9000 - Getting Started; Remote Control Preparation; Automatic Radio Station Setup; Setting the Clock

1 - 11
CHECK
10
Electrical Parameters are to be measured at speaker teminals across 3 ohm load with 500mW output and DSC setting in Jazz Mode
Bd3 -/+ <) zHK 1 ,Bd 0 ( ecnalabnU lennahC
01iaL ydnA : EMAN
Ver
A4
DATE :
SH 190 -8
Class No
FWM9000 All Version
2
3
1
SD-CARD Measurement at Set Level (*2)
Remarks :
Signal to Noise Ratio ( 0 dB, 1 KHz )
USB AND SD-CARD SPECICFICATION
Issued Date
08-09-2011
< +/- 3dB
Description
40HZ-16KHZ(reference 1KHZ)
40HZ-100HZ(Reference 63HZ)
200HZ-16KHZ(Reference 1KHZ)
>= 45dB (with 1 KHz filter )
USB Measurement at Set Level (*2)
Electrical Parameters are to be measured at speaker teminals across 3 ohm load with 500mW output and DSC setting in Jazz Mode
>= 55dBA ( A - weighted )
Description
) retlif zHK 1 htiw( Bd54=>) zHK 1 ,Bd 0 ( klatssorC lennahC
Specification
Specification
Channel Crosstalk ( 0 dB, 1 KHz )
) dethgiew - A ( ABd55 =>) zHK 1 ,Bd 0 ( oitaR esioN ot langiS
Channel Unbalance ( 0 dB, 1 KHz )
%2=<) zhK1 ,Bd0 ( esioN + DHT
) dethgiew - A (Bd55 =>) dethgiew - A ( ) zHk1,Bd0 ( oitaR esioN ot langiS
Channel Crosstalk ( ( 0 dB, 1 KHz ) ) >= 45dB
( 0 dB, 1 KHz ) >= 45dB
FWM9000 Frequency response @±4
Bd1 -/Vm038) zhK 1 ,Bd) ( mho k 33 = LR egatloV tuptuO
< = 1.5 kOhm
Channel Unbalance
GENERAL PART
Measurement are directly done at the connector on CDC board
< = +/- 3 dB
TECHNIAL DESCRIPTION
USB
See also SH 190 USB Audio Module (300605)
Measurment are directly done at the coonector on the board
(
*2
)
All speaker
"
R
"
channel
"
+
"
connect to equipment
"
+
"
for
All speaker
"
L
"
channel
"
-
"
connect to equipment
"
+
"
for measurement
noitacificepSnoitpircseD
Output Resistance