GC2810
2-5
DISASSEMBLY ADVICE
BACKPLATE 19
CORDSET 22
BALL SWIVEL 20
Remove screw A
Disassemble BACKPLATE 19
Disconnect 3x quick-connectors of CORDSET 22
Disassemble CORDSET 22
FILLING DOOR ASSY 18
INLAY PRINTED 17
SOS KNOB 15
SPRAY KNOB 16
SPRAY PUMP 9
SOS PUMP 10
LAMP ASSY 5
Disassemble FILLING DOOR ASSY 18
Remove screw B
Release rear catch of INLAY PRINTED 17
Disassemble INLAY PRINTED 17
Disconnect 2x quick-connectors of LAMP ASSY 5
Disassemble LAMP ASSY 5
THERMOSTAT DIAL PRINTED 21
WATER TANK ASSY 7
COVER 3
INSULATION SHEET 23
DOSING SEAL 13
SOS SEAL 14
SOLEPLATE MOUNTED ASSY 1
Disassemble THERMOSTAT DIAL PRINTED 21
Remove screws C (3x)
Disassemble WATER TANK ASSY 7
Remove screws D (3x)
Disassemble COVER 3
Note for re-assembly:
Please ensure that INSULATION SHEET 23 is put in place
during re-assembly.
This metal part acts as a heat sink to prevent softening of COVER
3 plastics at the screw location D1.
To Next Page
Loading...
