Vertical steam boost
1 The steam boost function can also be used when you hold the
iron in vertical position (fig. 13).
This is useful for removing creases from hanging clothes, curtains etc.
Never direct the steam at people.
Drip stop
This iron is equipped with a drip-stop function: the iron automatically
stops producing steam when the temperature is too low, to prevent
water from dripping out of the soleplate.When this happens you may
hear a sound.
Electronic safety shut-off function
(GC4440/GC4430/GC4420 only)
◗ The electronic safety shut-off function automatically switches off
the iron if it has not been moved for a while.
◗ The red AUTO/OFF light starts blinking to indicate that the iron
has been switched off by the electronic safety shut-off function
(fig. 14).
To let the iron heat up again:
- Pick up the iron or move it slightly.
- The red AUTO/OFF light goes out. If the temperature of the
soleplate has dropped below the set ironing temperature, the
amber temperature light goes on.
- If the amber temperature light goes on after you have moved the
iron, wait for it to go out before you start ironing.
- If the amber temperature light does not go on after you move the
iron, the soleplate still has the right temperature and the iron is
ready for use.
ENGLISH 11
To Next Page
Loading...
