Philips GC4420 - Preparation and Usage Guide

Preparing for use
Filling the water tank
1 Make sure the appliance is unplugged.
2 Set the steam control to position 0 (= no steam) (Fig. 2).
3 Open the cap of the lling opening.
4 Tilt the iron backwards and ll the water tank with tap water up to
the maximum level by means of the lling cup. (Fig. 3)
DonotllthetankbeyondtheMAXindication.
Do not put perfume, vinegar, starch, descaling agents, ironing aids or
other chemicals in the water tank.
If the tap water in your area is very hard, we advise you to mix it
with an equal portion of distilled water, or to use distilled water
only.
5 Close the cap of the lling opening (‘click’) (Fig. 4).
Setting the temperature
1 Type GC4444/GC4440 only: remove the heat-resistant protective
cover (Fig. 5).
Do not leave the heat-resistant protective cover on the soleplate
during ironing.
2 Put the iron on its heel and set the required ironing temperature
by turning the temperature dial to the appropriate position (Fig. 6).
Checkthelaundrycarelabelfortherequiredironingtemperature:
1 Syntheticfabrics(e.g.acrylic,nylon,polyamide,polyester)
1 Silk
2 Wool
3 Cotton
MAXlinen
Ifyoudonotknowwhatkindorkindsoffabricanarticleismadeof,
determinetherightironingtemperaturebyironingapartthatwillnotbe
visiblewhenyouwearorusethearticle.
,
-
-
-
-
-
ENGLISH8