This appliance is intended for household use only.
Electromagnetic elds (EMF)
This Philips appliance complies with all standards regarding electromagnetic elds (EMF). If handled
properly and in accordance with the instructions in this user manual, the appliance is safe to use
according to scientic evidence available today.
Before rst use
1
Remove any sticker or protective foil from the soleplate and clean the soleplate with a soft
cloth.
2 Fully unwind the mains cord and supply hose.
3 Place the steam tank on a stable, level surface.
4 Place the iron on the iron stand.
Preparing for use
Filling the steam tank
Never immerse the steam tank in water.
Do not open the steam tank cap when the iron and the steam tank are still hot.
Do not put perfume, vinegar, starch, descaling agents, ironing aids or other chemicals in the steam
tank.
1 Remove the mains plug from the wall socket.
2 Slowly unscrew the steam tank cap (Fig. 2).
Note: You may hear a sound when you remove the cap. This sound is caused by the vacuum or residual
pressure inside the steam tank and is perfectly normal.
3 Fill the steam tank with tap water up to the maximum level (max. 1 litre) (Fig. 3).
Note: If the tap water in your area is very hard, we advise you to mix it with an equal amount of distilled
water, or to use distilled water only.
4 Wipe away any water round the lling hole after lling.
5 Screw the cap tightly onto the lling aperture of the steam tank.
Fast rell
1 Keep the appliance plugged into the mains and make sure the iron switch is set to
‘on’. (Fig. 4)
2 Set the steam tank switch to ‘off’.
3 Press the steam activator until you no longer hear any steam escape from the
appliance (Fig. 5).
4 Place a piece of cloth over the steam tank cap.
5 Keep the steam activator pressed in and slowly unscrew the steam tank cap by turning it
anticlockwise.
This depressurises the steam tank.
6 Make sure there is no steam left in the steam tank.
,
ENGLISH 7
To Next Page
Loading...
Need help?
Power
Technical Specifications
Weight and Dimensions
