Philips GC6704 FastCare Compact - Page 20

20
ENGLISH
Problem Possible cause Solution
At the start of your
ironing session, the
steam trigger has not
been pressed long
enough.
Press and hold the
steam trigger until
steam comes out. It
may take up to 30
seconds until steam
comes out.
You have set the
temperature dial to ●.
Steam is not available
at ●. To use the steam,
set the temperature
dial to ●● or higher.
The light of
the CALC-
CLEAN button
ashes and the
appliance beeps.
This is the Calc-Clean
reminder.
Perform the Calc-
Clean after the Calc-
Clean reminder is
given (see chapter
‘Cleaning and
maintenance’).
No steam
comes out of
the soleplate,
the light of
the CALC-
CLEAN button
ashes and the
appliance beeps.
You have not done or
have not completed
the Calc-Clean
process.
Perform the Calc-
Clean process to
enable the steam
function again (see
chapter ‘Cleaning and
maintenance’).
The appliance
has switched o.
The auto shut-o
function is activated
automatically. The
appliance enters the
standy mode if it has
not been used for 15
minutes and switches
o if it has not been
used for another 10
minutes.
To switch on the
appliance again, set
the on/o switch to
“o” position and then
to “on” position.