Philips GC9620 - Repair Instruction - Self-Check Mode Entry; Enter Self-Check Mode Process

GC  GC

.. Enter SelfCheck mode Process Flow Chart
Start
Press and hold Power
& ECO buttons
Turn on mains power /
Plug in mains cord without
releasing buttons
Release the two buttons,
tank empty LED will
remain on for 3 sec
Enter
Self-Check mode
successfully?
Turn o mains power /
Unplug in mains cord
Tank empty
LED turns on?
YES
NO
Wait for at
least 5 sec
Press steam trigger twice
within 1 sec before tank
empty LED turns o
Entered
Self-Check mode
YES
NO
If fail to enter Self-Check mode,
could be due to:
1. No power to PCBA
2. Buttons malfunction
3. Steam trigger malfunction *
4. Timing incorrect
* Refer to Trouble shooting tip #9
- trigger press is not detected
Repair Instruction