10 ENGLISH
Problem Possible cause Solution
The appliance does not
produce any steam.
There is not enough water in the
water tank (the ‘water tank empty’
light ashes).
Fill the water tank (see chapter ‘Using your
appliance’, section ‘Filling the water tank’).
The appliance is not hot enough
to produce steam.
Wait until the ‘iron ready’ light on the iron lights up
continuously.
You did not press the steam
trigger.
Press the steam trigger and keep it pressed while
you iron.
The water tank is not placed in the
appliance properly.
Slide the water tank back into the appliance rmly
(‘click’).
The appliance is not switched on. Insert the plug in the wall socket and press the on/
o button to switch on the appliance.
The appliance has
switched o. The light
in the on/o button
ashes.
The auto-o function is activated
automatically when the appliance
has not been used for more than
10 minutes.
Press the power on/o button to switch on the
appliance again.
The appliance produces
a pumping sound.
Water is pumped into the boiler
inside the appliance. This is
normal.
If the pumping sound continues nonstop, switch o
the appliance and remove the plug from the wall
socket. Contact an authorised Philips service centre.
To Next Page
Loading...
Need help?
General
