Philips GoGear SA2ARA04 - 4 Update ARIAZ; Manually Verify; Update the Firmware

11
English
EN
4 Update ARIAZ
ARIAZ is controlled by an internal program
called rmware. Newer versions of the
rmware may have been released after you
have purchased ARIAZ.
The software program called Philips Songbird
can use your computer to check for rmware
updates that are available on the Internet.
Install Philips Songbird on your computer
(see chapter Install software) and follow the
instructions to update (see chapter Manually
verify / update the rmware).
Note
Your music les are not affected by a rmware •
update.
Manually verify / update the
rmware
1
Ensure that your computer is connected
to the Internet.
2 Connect ARIAZ to the computer
(see section Connect and charge for
instructions).
3 On your computer, click Start >
Programs > Philips > Philips Songbird to
launch the Philips Songbird application.
4 Select Tools > Updates
» Philips Songbird checks for updates
and installs new rmware from the
Internet, if available.
5 Follow the on-screen instructions to
update the rmware of ARIAZ.
6 Wait until the update is completed, then
disconnect ARIAZ from the computer.
ARIAZ restarts after the rmware is »
updated and is ready for use again.