Philips GoPure Power - Page 5

4
5
3 Installing the GoPure car air purier
m Note
• For your safety, do not
attempt to operate the
purier manually while
driving.
• Please don’t put
device on car
dashboard or airbag.
• The belt may not be
suitable to all car
models.
Place the belt over the
device as shown, with
the furry surface facing
the device.
Recommended
installation location is
on the rear headrest
or rear window sill.
3.1 Press the “OPEN”
button, lift the top cover
and remove the lter’s
plastic wrapping.
3.2 Installing and
connecting the console
It is recommended to
hide the wiring in the car
by following the route
illustrated in the above
diagram - through the
carpet - seat edge - rear
headrest.
Connect the power
cable to the
device as shown.
Connect the power
adapter to a 12V outlet
in your car.
m Important
When using Phillips GoPure
car purier,
• Keep using car ventilation at
low speed.
• Keep car windows closed.
0
m Note
Please note the following
troubleshooting
instructions:
E1: The device is not
connected to
power cable.
E2: The top cover of the
device is not
properly closed.







