The remaining tanning or relax time will appear on the display.
Shorten the tanning or relax time
C
11 Shorten the tanning or relax session by pushing the start button
(I).
The tanning lamps or infrared lamps will now be switched off.
12 Set a new time by means of the '-+' button.Wait until the time
indication on the display has stopped blinking and subsequently
press the start button (I).
HB875 only:The new time is visible on the display but does not blink.You
will have to watch the three minutes yourself (this only applies to the
tanning lamps;the infrared lamps come on right away.
Switching from a relax to a tanning session (type HB875 only)
◗ When you switch from a relax session to a tanning session,bear in mind
that the tanning lamps will not go out right away.It will take a little while
before they go on.
C
◗ To be able to use the infrared lamps ('l relax' setting), both side lamp
units and the centre lamp unit should have been put in the right position.
◗ Before you switch on the solarium,check whether the selector switch (B)
has been set to the desired position ('; sun' for a tanning session or 'l
relax' for a relax session).
◗ Make sure the right lamps are switched on:
B
For the tanning session:4 lamps (one in every lamp unit) that emit bluish light;
B
For the relax session:2 lamps (one in every side lamp unit) that emit red light.
Cleaning
1 Always unplug the appliance and let it cool down before you start
cleaning it.
2 Clean the outside of the appliance with a damp cloth.
Do not let any water run into the appliance.
3 Do not use any scouring agents or scouring pads.
Never use abrasive liquids like scourers,petrol or acetone to clean the
appliance.
◗ You can clean the outside of the UV filters with a soft cloth sprinkled with
some methylated spirits.
Storing
1 Let the appliance cool down for 15 minutes before you put it in
transport position and store it.
◗ In the meanwhile you can roll up the cord and put it in the base of the
appliance,together with the remote control.
C
2 Store the cord and remote control carefully,as they might get
stuck when you put the appliance in transport position.
ENGLISH
13
To Next Page
Loading...
