Never immerse the appliance in water or rinse it
under the tap.
Note: Only the cutting element and the comb can be
cleaned with water.
1 Make sure the appliance is switched off and
disconnected from the mains.
2 Wipe the housing of the appliance with a dry
cloth.
3 Push the comb off the appliance and clean it
with the brush or rinse it under the tap.
Caution: Make sure that the comb is dry before
you reattach it to the appliance.
4 Press the release button (1). The cutting
element comes off the appliance (2).
5 Clean the cutting element with the brush or
rinse it under the tap. Shake off excess water
and leave to dry.
Caution: Do not dry the cutting element with a
towel, as this may damage the cutting element
Caution: Make sure that the cutting element is dry
before you reattach it to the appliance.
6 Clean the inside of the appliance with the
brush.
Never immerse the appliance in water or rinse it
under the tap.
1
2
ENGLISH
23
To Next Page
Loading...
