Philips HC3410 - Replacing the Cutting Unit

5 Clean the cutting unit with the brush or rinse
it under the tap.
6 Clean the inside of the appliance with the
brush.
Never immerse the appliance in water or rinse it
under the tap.
7 Shake off excess water. To reattach the cutting
unit, insert the lug of the cutting unit into the
guiding slot.
8 Insert the lug of the cutting unit into the
guiding slot (1) and push the cutting unit back
onto the appliance (2).
Replacement
Only replace a worn or damaged cutting unit with
an original Philips cutting unit, available from
authorised Philips service centres.
1 Press the release button (1). The cutting unit
comes off the appliance (2).
2 Insert the lug of the new cutting unit into the
guiding slot (1) and push the cutting unit back
onto the appliance (2).
1
2
1
2
1
2
ENGLISH
24