2 Press the release button (1) and remove the cutting unit (2).
3 Insert the screwdriver between the motor unit and the back panel
of the appliance. Press down the screwdriver as far as it will go
4 Tilt the handle of the screwdriver downwards (1) and separate
the back panel from the appliance (2).
5 Remove the side panels. Pull the bottom part of the printed circuit
board with the rechargeable battery attached from the appliance.
6 Cut the wires to separate the rechargeable battery from the
appliance.
Do not connect the appliance to the mains again after you have opened it.
Guarantee and support
If you need information or support, please visit www.philips.com/
support or read the separate worldwide guarantee leaet.
1
2
2
1
ENGLISH10
To Next Page
Loading...
