7 Insert the lug of the cutting unit into the guiding slot (1) and push
the cutting unit back onto the appliance (2).
Note: If the message ‘CL’ is shown on the display, too much hair has collected
between the comb and the cutting unit. Remove the comb and cutting unit and
clean them with the cleaning brush supplied. Also clean the top edge of the
handle with the cleaning brush supplied.
Replacement
Only replace a worn or damaged cutting unit with an original Philips cutting
unit, available from authorised Philips service centre.
1
Press the release button (1). The cutting unit comes off the appliance (2).
2 Insert the lug of the new cutting unit into the guiding slot (1)
and push the cutting unit onto the appliance (2).
Ordering accessories
To buy accessories or spare parts, visit www.shop.philips.com/service
or go to your Philips dealer. You can also contact the Philips Consumer
Care Centre in your country (see the worldwide guarantee leaet for
contact details).
Recycling
Do not throw away the appliance with the normal household waste at
the end of its life, but hand it in at an ofcial collection point for recycling.
By doing this, you help to preserve the environment.
Removing the rechargeable battery
Note: We strongly advise you to have a professional remove the
rechargeable battery.
Only remove the rechargeable battery if it is completely empty.
1 Disconnect the appliance from the mains and let the appliance
operate until the motor stops.
1
2
1
2
1
2
ENGLISH 9
To Next Page
Loading...
