Cleaning
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as alcohol, petrol or acetone to clean the appliance.
Never immerse the appliance in water or rinse it under the tap.
1 Make sure the appliance is switched off and disconnected from the
mains.
2 Wipe the housing of the appliance with a dry cloth.
3 Remove the comb and clean it with the brush.
4 Press the release button (1). The cutting unit comes off the appliance (2).
5 Clean the cutting unit with the brush.
6 Clean the inside of the appliance with the cleaning brush.
Never immerse the appliance in water or rinse it under the tap.
7 Insert the lug of the cutting unit into the guiding slot (1) and push
the cutting unit back onto the appliance (2).
Note: If the message ‘CL’ is shown on the display, too much hair has collected
between the comb and the cutting unit. Remove the comb and cutting unit and
clean them with the cleaning brush supplied. Also clean the top edge of the
handle with the cleaning brush supplied.
ENGLISH8
To Next Page
Loading...
