Philips HC7460 - Philips Trimmer HC7460 Parts, Accessories, and Disposal; Philips Trimmer HC7460 Cutting Unit Replacement; Philips Trimmer HC7460 Ordering Accessories; Philips Trimmer HC7460 Recycling Information

7 Insert the lug of the cutting unit into the guiding slot (1) and push
the cutting unit back onto the appliance (2).
Note: If the message ‘CL’ is shown on the display, too much hair has collected
between the comb and the cutting unit. Remove the comb and cutting unit and
clean them with the cleaning brush supplied. Also clean the top edge of the
handle with the cleaning brush supplied.
Replacement
Only replace a worn or damaged cutting unit with an original
Philips cutting unit, available from authorised Philips service centre.
1 Press the release button (1). The cutting unit comes off the
appliance (2).
2 Insert the lug of the new cutting unit into the guiding slot (1)
and push the cutting unit onto the appliance (2).
Ordering accessories
To buy accessories or spare parts, visit www.shop.philips.com/service
or go to your Philips dealer. You can also contact the Philips Consumer
Care Centre in your country (see the worldwide guarantee leaet for
contact details).
Recycling
- This symbol on a product means that the product is covered
by European Directive 2012/19/EU.
1
2
1
2
1
2
ENGLISH 11
12 / 138