9
4 Press the pre-ground coffee button to switch
• The button lights up when you press it.
D
Note:
When you switch off the grinder, the number
of cups and the strength setting are not
shown on the display.
5
D
Note:
How much pre-ground coffee you use is a
matter of personal taste. For a medium-strong
cup of coffee, use one measuring spoon
6
the jug on the hotplate.
7 Follow steps 7, 8 and 9 in section ‘Using coffee
beans’.
5.4 Drip stop function
The drip stop function enables you to remove
the jug from the coffeemaker before the brewing
D
Note:
The brewing process does not stop when you
remove the jug. If you do not put the jug back
8 Wait until the coffeemaker has stopped
beeping before you remove the jug from the
hotplate.
D
Note:
basket for several seconds.
• The freshness indicator ashes slowly on
the display for 120 minutes after brewing, to
indicate that the coffee is fresh.
9 If you do not need the hotplate to keep the
coffee hot, press the start/standby button to
• The appliance produces a long beep and
the start/standby button stays on to indicate
that the appliance is still switched on.
D
Note:
If you do not press the start/standby button
to put the appliance in standby mode,
the appliance goes into standby mode
automatically after 120 minutes. The start/
standby button stays on to indicate that the
appliance is still switched on.
D
Note:
You can press any button to activate the
appliance and brew coffee again.
10 If you do not intend to brew coffee again
soon, set the on/off switch on the back of the
appliance to ‘O’ to switch off the appliance.
5.3 Using pre-ground coffee
If you want to use pre-ground coffee instead of
coffee beans, follow the steps below.
1 Fill the water reservoir with water, as
described in ‘Filling the water reservoir’.
2 Press the OPEN button on the right-hand
3
ENGLISH
To Next Page
Loading...
