4 Put pre-ground coffee in the paper filter or in the permanent filter.
Note: How much pre-ground coffee you use is a matter of personal taste. For a medium-strong cup
of coffee, use one measuring spoon (approximately 6g) for each cup (125ml).
5 Close the filter basket holder.
6 Press the start/standby button.
The appliance beeps and the display lights up.
7 Press the pre-ground coffee button to switch off the grinder (Fig. 5).
The button lights up when you press it.
Note: When you switch off the grinder, the number of cups and the strength setting are not shown
on the display.
8 Press the start/standby button again to start the brewing process (Fig. 2).
Warning: Keep away from the steam vent during brewing, as hot steam escapes
through the vent.
-
The coffeemaker beeps 5 times when the brewing process is finished.
9 Wait until the coffeemaker has stopped beeping before you remove the glass jug.
Note: After brewing, coffee drips from the filter basket for several seconds.
-
The freshness indicator (cup symbol) flashes slowly on the display for 120 minutes after brewing,
to indicate that the coffee is fresh (Fig. 13).
Drip stop function
The drip stop function enables you to remove the glass jug from the coffeemaker before the brewing
process is finished. When you remove the glass jug, the drip stop stops the flow of coffee into the
glass jug.
Note: The brewing process does not stop when you remove the glass jug. If you do not put the glass
jug back in the appliance within 20 seconds, the filter basket overflows.
Cleaning and maintenance
Cleaning after every use
Never immerse the appliance in water or any other liquid, nor rinse it under the tap.
1 Remove the mains plug from the wall socket.
2 Wipe the outside of the coffeemaker with a damp cloth.
3 Clean the filter basket and the permanent filter with hot water and some washing-up liquid or
clean them in the dishwasher.
Cleaning the coffee bean chute
You have to clean the coffee bean chute every 1 to 2 weeks, depending on the frequency of use.
1 Put the mains plug in the wall socket.
2 Press the start/standby button (Fig. 2).
Note: Make sure that the light in the pre-ground button is off.
-
The display lights up.
10
English
To Next Page
Loading...
Need help?
General
