Philips HD7825/62 - Page 18

4 Placethe1-cuppodholderq with a used coffee pod in it in the
coffee machine. Close the lid and make sure it is properly locked.
It is not possible to descale the machine when the lid is not properly
closed and the lid lever is not locked. In this case, the indicator
lightashesintermittently.
Note: Always put a used coffee pod in the pod holder when you descale the
machine. This pod serves as a ‘lter’ to prevent the sieve or hole in the pod
holder from getting clogged with scale residue.
5 Put a bowl with a capacity of at least 1500ml under the spout to
collect the descaling mixture.
6 Pressthe1-cupbuttonqandthe2-cupbuttonqqbrieyatthe
same time to start the descaling cycle.
, The CALC light and the light ring around the on/off button starts
ashingtoindicatethatthedescalingcyclehasstarted.
, Hot water comes out of the coffee spout in intervals. During the
descaling cycle, the machine stops descaling 3 to 4 times to let the
descaler mixture act and to heat up.
Let the machine complete the entire descaling cycle, which takes 4 to
5 minutes. Do not switch off the machine during the descaling cycle!
, When all the water in the water reservoir has been used up, the
descalingcycleisnished.Thelightringaroundtheon/offbutton
startstoashrapidly.
7 Repeat the descaling procedure (steps 2 to 6) once. Replace the used
podwithanotherusedpodtolteroutthescaleresidue.
8 Rinse the water reservoir with tap water. Fill the water reservoir up
to the MAX indication with tap water and repeat steps 3 and 6.
Note: Do not rell the water reservoir with used hot water or the used
descaling mixture.
9 Fill the water reservoir with fresh tap water up to the MAX
indication again and repeat steps 5 and 6 once more.
Note: Always rinse the machine by letting it empty two full water reservoirs.
10 Remove the used pod and clean the pod holder after descaling to
prevent the sieve in the centre from getting clogged.
ENGLISH18