Problem Solution
The light wakes me
too early or too late.
Perhaps the light intensity level you have set is not appropriate for
you. Try a lower light intensity level if you wake up too early or a
higher intensity level of you wake up too late. You can also change
the duration of the wake-up curve. If light intensity 1 is not low
enough, move the appliance further away from the bed. If the light
intensity is not high enough to wake you, make sure that the light of
the appliance is not blocked by any object and the appliance is
nearby.
I am unable to turn
the Midnight Light
function on/off.
Make sure you tap on the correct position (top/back) of the
appliance.
I am unable to stream
music via USB.
The USB connection is only for charging your mobile phone. You are
not able to stream music to the connected Sleep & Wake-Up Light.
The aux inlet doesn't
work properly.
Try to set the volume on your smartphone either higher or lower. If
necessary, adjust the volume level on the appliance as well.
Suddenly the
appliance makes a
beeping sound.
The backup alarm went off. This can happen up to 8 hours after the
power was removed and a set alarm time is due. The alarm sound
stops automatically after approximately 1 minute. You also can stop
the alarm sound immediately if you power up the appliance for a
brief moment.
To prevent the back-up alarm from going off when the power is
removed (e.g. storage) disable the alarms prior to powering down.
Safety and compliance
This appliance meets the safety requirements in the USA and Canada
for:
- UL 153, CSA-C22.2 No. 250.4-14 (Portable Electric Luminaires)
- UL 8750 (Light Emitting Diode (LED) Equipment for Use in Lighting
Products)
- UL 60065, CSA-C22.2 No. 60065-03 (Audio, Video and Similar
Electronic Apparatus – Safety)
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic fields.
25
English
To Next Page
Loading...
