Philips HP3132 - Page 6

Tanning while seated
(one or two persons: the
upper part of the body)
- Unlock the upper casing
by pushing on the shorter
side of the clips (fig. 7).
— Pull the stand and the
upper part of the solarium
upwards (fig. 8).
~ The upper casing is
locked into a horizontal
position (fig. 9).
- Turn the upper casing into
the required position
(fig. 10).
— Sit down at a distance of
approx. 1.00 m.(40”) from
the solarium (fig. 11). Use
the distance meter for this
purpose.
Setting the session time
e For type HP 3132 please refer to section "The remote
control unit” and illustrations 12 - 21.
e For type HP 3135 please refer to section ’Setting the
timer” and illustration 22.
The remote control unit
e The appliance is connected to the mains power
(fig. 12).
Time setting button for 10 or 20 minutes (left hand
symbols in the display).
Time setting button for 0 - 9 minutes (right hand
symbols in the display).
Start button. When this button is depressed the sun
lamps and the timer are switched on.
Pause button. If the session must be interrupted
(e.g. when the telephone rings), you press this
button.
The sun lamps will go out and in the display 00 will
appear. The remaining time for the session will be
stored in the memory of the timer.
Blink signal. This signal indicates that the timer is in
function.
@ Bleeper. This sound signal indicates that the last
minute of the time set for the tanning session has
been entered.
(If you should wish the solarium to operate longer
than Na set time, it is advisable to set the new time
now.
© oO 6 O
.°)
© Display. You can use the display for setting the timer.
During the session the display shows the blink signal
and the remaining time.
Attention
¢ The following illustrations show in red print which
push-button must be actuated. In.-the same
manner is indicated which symbol in the display
will change then. (The depicted symbols. are
merely
examplary.)°
ego
When the sun lamps are switched on you will see
oo ae signal (a blinking red dot next to the
igits). oe.
oar)
in the following cases. you will see 00 in the
display: © 08. ge as -
~ when the plug is connected to.a wall socket;
~ at the end of the tanning session;
~ when the pause button (d) has been depressed;
~ after a mains failure.
in all these situations the sun lamps are
- automatically switched off.