Philips HP6342 - Preparing for Use; Inserting Batteries; Shaving Head Attachment;Detachment; Attachment Handling


The Ladyshave runs on two AA 1.5 volt alkaline batteries. We advise you
to use Philips LR6 PowerLife batteries. They supply sufcient energy for
approx. 40 minutes of shaving.
Note: Make sure that your hands are dry when you insert the batteries.
To avoid damage due to battery leakage:
- Do not expose the appliance to direct sunlight.
- Do not expose the appliance to temperatures higher than 35°C.
- Remove the batteries if you are not going to use the appliance for a
month or more.
- Do not leave empty batteries in the appliance.

1 To remove the battery compartment cover, pull it off the
appliance (Fig. 3).
2 Put the batteries in the battery holder (Fig. 4).
Note: Make sure that the + and - poles of the batteries point in the right
direction.
3 Push the battery compartment cover back onto the appliance
(‘click’) (Fig. 5).

1 To detach the shaving head, press the release buttons on both sides
of the appliance (1) and pull the shaving head (2) (Fig. 6).
2 To attach the shaving head push it onto the appliance.
Note: Do not exert pressure on the shaving foil to avoid damage.

HP6342 comes with the protection cap, the efciency cap and the
trimming comb. HP6340 comes with the protection cap. All attachments
can be attached and detached in the same way.
8