Philips HP8180 - Page 4

•
For additional protection, we advise
you to install a residual current
device (RCD) in the electrical circuit
that supplies the bathroom. This
RCD must have a rated residual
operating current not higher than
30mA. Ask your installer for advice.
• Do not insert metal objects into the air grilles to avoid electric
shock.
• Never block the air grilles.
• Before you connect the appliance, ensure that the voltage
indicated on the appliance corresponds to the local power
voltage.
• Do not use the appliance for any other purpose than described in
this manual.
• Do not use the appliance on articial hair.
• When the appliance is connected to the power, never leave it
unattended.
• Never use any accessories or parts from other manufacturers
or that Philips does not specically recommend. If you use such
accessories or parts, your guarantee becomes invalid.
• Do not wind the mains cord round the appliance.
• If the appliance overheats, it switches off automatically. Unplug
the appliance and let it cool down for a few minutes. Before you
switch the appliance on again, check the grilles to make sure they
are not blocked by uff, hair, etc.
Noise Level: Lc = 83dB [A]