6 Brush the guard.
7 Put the shaving heads back into the shaving unit. Put the retaining
frame back into the shaving unit, push it down (1) and turn the wheel
clockwise (2).
8 Put the shaving unit back onto the shaver.
Extra-thorough cleaning
For extra-thorough cleaning, put the shaving heads in a degreasing liquid
(e.g. alcohol) every six months. To remove the shaving heads, follow steps
1 to 4 described above. After cleaning, lubricate the central point on the
inside of the guards with a drop of sewing machine oil to prevent wear of
the shaving heads.
Trimmer (HQ6996, HQ6990, HQ6976, HQ6950, HQ6946 only)
Clean the trimmer every time you have used it.
1 Switch off the shaver. Remove the mains plug from the wall socket
and pull the appliance plug out of the shaver.
2 Clean the trimmer with the cleaning brush supplied.
Tip: Lubricate the trimmer teeth with a drop of sewing machine oil every six
months.
Storage
1 Put the protection cap on the shaver to prevent damage.
ENGLISH 9
To Next Page
Loading...
