Service Manual
Philips Consumer Lifestyle
Published by Philips Consumer Lifestyle Printed in the Netherlands © Copyright reserved Subject to modification
Shaver
HQ6645
08/10
PRODUCT INFORMATION
Shaving system
- 3-dimentional contour following system
- Lift & Cut system
- Individually floating heads
- Three Super Reflex Action shavingheads HQ55
- Silent power
- Hair collecting chamber
Power system
- Mains operation
- World-wide automatic voltage selection
Features
- Pop-up trimmer
Luxe
*
Safety information
- This product meets the requirements regarding
interference suppression on radio and TV.
- After the product has been repaired, it should function
properly and has to meet the safety requirements as
officially laid down at this moment.
TECHNICAL INFORMATION
- Voltage : 100-240 V AC 50-60 Hz
- Power consumption : Motor depending
- Motor Voltage : 54 V
- Power system : Mains
- Shaving heads : HQ55 - 4222 036 08370
- SAP coding : HQ6645
DISASSEMBLY- AND RE-ASSEMBLY ADVISE
- Remove shaving unit, to prevent damages during repairs.
- Remove the screws A1 (2x).
- Remove cover. (See Fig. 1)
- To remove the trimmer, first
disassemble the trimmer slide
by pushing down the locking
pegs (2 x “X” in exploded view)
and move the slide slightly
outwards.
- Make room between trimmer
and cover with a small screw-
driver (“Y” in exploded view).
- Remove screws B1 (2 x).
- The PC-board with motor
and hairchamber can now be
removed from the housing.
- Detach the motor clamping springs (item 17) on the
bearing block with a small screwdriver
REPAIR INSTRUCTION
- No specific issues
OPTIONAL (accessories)
- No specific issues
Fig. 1
To Next Page
Need help?
General
