EasyManua.ls Logo

Philips HR7783 - General Assembly

Philips HR7783
144 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
English
EN
4 Put the lid on the bowl, and turn the lid
clockwise until you hear a click to x it. Then
put the pusher into the feeding tube.
For the discs, put the ingredients into the
feeding tube with the pusher.
5 Connect the power plug to the power
supply.
6 Check the advised ingredient quantity and
setting in Table 10. Turn the knob to the
desired speed setting.
7 After use, turn the knob to OFF, and then
unplug the appliance.
Discs
Before you start, make sure that you pick your
desired disc from following and assemble
according to Fig. 2:
Name Purpose
Reversible
shredding
disc
For shredding
ingredients into
thin or thick at
pieces with the
reversible sides
Adjustable
slicing disc
For slicing
ingredients to the
slicing thickness
you set
Julienne
disc
(HR7778,
HR7783)
For cutting
ingredients into
thin strips
Granulating
disc
(HR7778,
HR7783)
For granulating
ingredients to
small/ne pieces
French
fry disc
(HR7778,
HR7783)
For cutting
ingredients into
thick strips.
3 Type the product number “HR7776, HR7778
or HR7783” in the search box.
4 Find or download the information you need
from the searching result.
5 For inspiring recipes, pls visit www.philips.
com/kitchen.
Motor thermal protection (Auto-
stop protection against overload)
Your food processor is designed to be
protected from overheating and over-current
conditions during use.
In case of overload, it will automatically stop to
prevent motor damage.
To reset the appliance, follow the steps below:
1 Turn the knob to OFF position and then
unplug it.
2 Remove some of the ingredients to reduce
the load.
3 Allow the appliance to cool down for
20 minutes.
4 Connect the power plug to the power supply
and reselect the desired speed.
3 Use your food
processor
General Assembly
Before you use or assemble any of the
accessories, make sure that you assemble
according to Fig. 2 to 9.
1 Turn the bowl clockwise until you hear a
click to x it onto the motor unit.
2 Assemble the accessory or the accessory
equipped with the shaft to the bowl.
3 Put the ingredients in the bowl.
For the citrus press, press the citrus fruits
on the cone, and go to Step 5.

Related product manuals