16
MP3 player
Connect your MP3 player to play your audio les
or music.
What you need
• An MP3 player.
• A 3.5mm stereo audio cable.
Play music
1 Connect the MP3 player to the home
theater as described in the Quick start
guide.
2 Press AUDIO SOURCE repeatedly until
‘MUSIC I-LINK’ appears on the display
panel.
3 Press the buttons on the MP3 player to
select and play audio les or music.
Create MP3 les
Use your home theater to convert audio CDs into
MP3 les.
What you need
• An audio disc.
• A USB storage device
1 Connect a USB storage device to the home
theater.
2 Play your audio CD (CDDA/HDCD).
3 Press CREATE MP3.
» A conrmation message is displayed.
4 Select [Yes], and then press OK.
» The create MP3 screen is displayed. The
right panel contains MP3 settings and the
left panel shows the audio tracks.
Tune stations
1 Connect the FM antenna as described in the
Quick start guide.
2 Press RADIO.
» If you have already installed the radio
stations, the last channel that you listened
to is played.
» If you have not installed any radio
stations, the message AUTO INSTALL...
PRESS PLAY appears on the display
panel. Press
(Play).
3 Press the following buttons to listen or to
change radio stations:
Button Action
/
Select a preset radio station.
Navigation
buttons
(left/right)
Search for a radio station.
Navigation
buttons
(up/down)
Fine tune a radio frequency.
Press to stop the installation of
radio stations.
Press and hold to erase the preset
radio station.
PROGRAM Manual: Press once to access
program mode, and press again to
store the radio station.
Automatic: Press and hold for
three seconds to reinstall the
radio stations.
Listen to radio
1 Press RADIO.
• To listen to a preset station, press
or
.
• To search for a radio station, and then
listen, press Navigation buttons (left/
right).
2 Press +/- (Volume) to change the volume.
EN
To Next Page
Loading...
