2 - 12 - 1
System , Region Code , etc. Setting Produre
1)Restore factory setting
a) Press <SETUP> button on R/C
b) Select <preference setup> ,then press < OK >
c) Select <default>,then press <OK> to con rm
2)Version control change
a) Open the Door,then,press “1” “5” “9” on RC
b) Press <OK> button on RC
c) TV will show message as follow:
3)Password change
a) Press <SETUP> button on R/C
b) Select <preference setup> ,then press <OK>
c) Select <password> <change>,then press <OK> to con rm
“0000” is default password supplied.
4)Trade model
a) Press <Open/Close>button on R/C
b) Press “2” “5” “9” on R/C,VFD will display “TRA ON “ or “TRA
OFF“
5)Check on software version
a) Press <SETUP> button on R/C
b) Select <preference setup> ,then press <OK>
c) Select <version info>,then press <OK>
d) TV will show message as follow:
6) Upgrading new software
a) Copy the latest upgrading software onto a CD-R or USB storage
device
b) Insert the CD-R program disc or connect the USB storage device
to the home theater
c) TV will show message as follow
d) Select <OK>,the home theater will start to upgrading
automatically
Note: when upgrade in progress, please do not unplug or switch off
the device.
when the updated is complete ,the home theater automatically
switch to standby.
CAUTION!
This information is confi dential and may not be
distributed.Only a qualifi ed service person should
reprogram the Region Code.
Preference setup
Ver sion Info.
Current model: 5540-12
Version :00.08.00_0 Release: 2009.12.22
Region: 2 Servo: AE .57.F1.00
8032:05.00.04.06 Resc: AA.00.00.00
MCU: 07.00 Touch: 0009
TX: Error RX: Error
OK
Press SETUP to exit menu
Upgrade fi le detected
Do you wish to continue with
the software upgrade?
OK Cancel
Current model: 5540-12
Version:00.08.00_0 Release:2009.12.22
Region: 2 Servo:AE.57.F1.00
8032: 05.00.04.06 Risc: AA.00.00.00
MCU: 07.00 Touch: 0009
TX: Error RX: Error
if current model does not match you set,
use down arrow key on the remote to change
OK
To Next Page
