15
Setting up the Measurement
Servers
1 Decide which measurements you want to make.
2 Connect the required Measurement Servers, or
Measurement Server Extensions.
3 Check that you have the correct patient cables and
transducers plugged in. The connectors are color-
coded to the patient cables and transducers for easy
identification.
Starting Monitoring
After you switch on the monitor,
1 Admit your patient to the monitor.
2 Check that the profile, alarm limits, alarm and QRS
volumes, patient category and paced status and so
forth are appropriate for your patient. Change them
if necessary.
3 Refer to the appropriate measurement section of the
Instructions for Use for details of how to perform
the measurements you require.
To Next Page
Loading...
Need help?
General
