2 Configuring Profiles and Settings Blocks Unlocking a Settings Block or Profile
18
Unlocking a Settings Block or Profile
Profiles and settings blocks can be locked to prevent them from being modified or deleted. This
ensures that a minimum configuration is always available. A locked Profile or settings block is
identified (in configuration mode only) by a lock symbol.
You cannot unlock Profiles or settings blocks in the monitor’s configuration mode. To lock or
unlock Profiles or settings blocks you need to use the IntelliVue Support Tool.
Configuring a Second / Third Main Display
To distinguish between individual main displays, the displays are numbered on the Screen. The number is
shown next to the Screen Name field.
A second main display can be used with
• an MX800 with Independent Display Interface, or MP90 with a Dual CPU, or
• an MX800, MP2/X2, MP5, MP60/70, MP80, MP90 with a single CPU, when using an XDS Remote
Display as the second display.
Display 1 is always the built-in display, or the display connected to the first CPU of the Dual CPU
MP90 monitor.
Display 2 is the display connected:
• to the Independent Display Interface of the MX800
• to the second CPU of the Dual CPU of the MP90 monitor
• to the XDS Remote Display.
A third main display can be used with
• a D80 Intelligent Display connected to a Dual CPU MP90 monitor, or
Display 1 Display 2
Profiles
Profile : ICU B
Patient Category : Adult
Paced : Yes
Display 1 : 6 Waves B
Display 2 : 12 Lead ECG
Measmnt. Settings : Measmt. B
Monitor Settings : Monitor B
To Next Page
Loading...