16
English
3140 115 27761
Tape Recorder
STOP • OPEN
PAUSE
INCREDIBLE SURROUND
PLAY
RECORD
Tape playback
1 Select TAPE source.
➜ The display shows TAPE throughout tape
operation.
2 Press STOP•OPEN to open the tape door.
3 Insert a recorded tape and close the tape door.
¶ Load the tape with the open side downward and
the full spool to the left.
4 Press PLAY 2 to start playback.
5 To interrupt playback press PAUSE. To resume,
press this key again.
6 By pressing à or á on the system fast winding
of tape is possible in both directions.
7 To stop the tape, press STOP•OPEN.
¶ The keys are automatically released at the end of
the tape, except if PAUSE has been activated.
Note:
– The sound source cannot be changed while
playing or recording a tape.
General Information on
Recording
¶ Recording is permissible insofar as copyright or
other rights of third parties are not infringed.
¶ For recording, use only NORMAL (IEC type I)
tapes on which the tabs have not yet been
broken. This deck is not suited for recording on
METAL (IEC IV) type tapes.
¶ The best recording level is set automatically.
Altering the VOLUME, INCREDIBLE
SURROUND, DBB or INTERACTIVE SOUND
controls will not affect the recording in progress.
¶ At the very beginning and end of the tape, no
recording will take place during the 7 seconds
when the leader tape passes the recorder heads.
¶ To protect a tape from accidental erasure, have
the tape in front of you and break out the left
tab. Recording on this side is no longer possible.
If, however, you wish to record over this side
again, cover the tabs with a piece of adhesive
tape.
Synchro Start CD recording
1 Select CD source.
2 Insert a disc and if desired, program track
numbers.
3 Press STOP•OPEN to open the tape door.
4 Insert a suitable tape into the deck and close the
tape door.
5 Press RECORD to start recording.
➜ Playing of the disc program starts
automatically from the beginning of the disc/
program after 7 seconds. It is not necessary to
start the CD player separately.
To select and record a particular passage
within a track:
¶ Press and hold down on PREV ¡1 or NEXT
2™ (on the remote control à or á ).
¶ When you recognize the passage you want,
release PREV ¡1 or NEXT 2™.
¶ To interrupt disc playback press PLAY•PAUSE
2; (on the remote control SIDE/;).
¶ Recording will begin from this exact point in the
track when you press RECORD.
6 For brief interruptions during recording, press
PAUSE. To resume recording, press PAUSE
again.
pg 001-021/MC10/37-Eng 12/8/00, 9:10 AM16
To Next Page
Loading...
